Marco Herzog

- creating tire model for simulations
- responsible for Vertical Dynamics of the car (simulation and 4-post test bench validation)
- responsible for set-up and car balance
- designing and perfoming FEA simulations for topology optimized front uprights with structure to attach gearbox inside of it
- perfoming damper tests on hydraulic test bench

- project management to assure design and manufacturing of race car in time
- supervise individual departments
- organizing events such as recruiting events and race car rollout
- preparing team for static disciplines (Engineering Design, Cost & Manufacturing)
- organizing test days and preparing them with test plans
- preparing meetings for departments and pre-/ post meetings for testdays
- creating test protocolls while testing
- organization of race events (from arrival to static and dynamic disciplines)
- contact person between university and team

- organization and management of department
- responsible for point-mass Lap Time Simulation
- gathering tire data from inhouse tire test bench
- comparing different tires based on their test bench performance
- selecting tire for the race car
- designing the kinematics including tools to find kinematic target values
- creating tire model for simulations
- Acquistion and Evaluation of Data
- responsible for car set-up and balance at testing and for dynamic disciplines
- designing and perfoming FEA simulations for topology optimized front uprights with structure to attach gearbox inside of it
- adapting Torque Vectoring on track while testing and at the events
- presenting the Engineering Design at 4 events and one Design Final at FS East

- support with manufacturing
- responsible of the brake system, car setup and tires
- presenting Engineering Design of Vehicle Dynamics and Kinematics at 4 Events
- design and FEA simulation of milled upright
- Acquistion and Evaluation of Data

- FEA simulation of various parts

- manufacturing and assembly of components
- presenting Engineering Design and Cost & Manufacturing at two Events

- CAD design (serial parts and prototypes)

- project management

- creating and releasing first article inspection (FAI) reports

- CAD design and quality assurance